Userbase

Code: Selecteer alles

4.4.3    
Setting the RAID item in BIOS
You must enable the RAID function in the BIOS Setup before creating RAID set(s) using
SATA HDDs. To do this:
1.     Enter the BIOS Setup during POST.
3.     Set the Configure SATA as item to [RAID].
2.    
4.    
Go to the Main menu > Storage Configuration, and then press <Enter>.
Save your changes, and then exit the BIOS Setup.
Refer to Chapter 3 for details on entering and navigating through the BIOS Setup.
4.4.4    
Intel® Matrix Storage Manager option ROM utility
The Intel® Matrix Storage Manager Option ROM utility allows you to create RAID 0, RAID 1,
RAID 10 (RAID 0+1), and RAID 5 set(s) from Serial ATA hard disk drives that are connected
to the Serial ATA connectors supported by the Southbridge.
To enter the Intel® Matrix Storage Manager option ROM utility:
1.    
2.    
Turn on the system.
During POST, press <Ctrl+I> to display the utility main menu.
Intel(R) Matrix Storage Manager option ROM v8.0.0.1038 ICH10R wRAID5    
Copyright(C) 2003-08 Intel Corporation.  All Rights Reserved.
    
[ MAIN MENU ]
      1. Create RAID Volume              3. Reset Disks to Non-RAID    
      2. Delete RAID Volume              4. Exit
RAID Volumes:    
None defined.
Physical Disks:
Port Drive Model    Serial #             Size      Type/Status(Vol ID)
0    ST3160812AS    9LS0HJA4             149.0GB   Non-RAID Disk
1    ST3160812AS    9LS0F4HL             149.0GB   Non-RAID Disk
2    ST3160812AS    3LS0JYL8             149.0GB   Non-RAID Disk
3    ST3160812AS    9LS0BJ5H             149.0GB   Non-RAID Disk
       [↑↓]-Select    
  [ESC]-Exit          [ENTER]-Select Menu
The navigation keys at the bottom of the screen allow you to move through the menus
and select the menu options.
    
[ DISK/VOLUME INFORMATION ]
                
The RAID BIOS setup screens shown in this section are for reference only and may not
exactly match the items on your screen.
The utility supports maximum four hard disk drives for RAID configuration.