Please check
How is Fiber installed
Basic installation consists of 3 elements:
- ONTP (fiber termination point).
- XGS-PON ONT (the fiber modem).
- Internet Box (the router)
For pictures, check Google for "ONTP", "ONT" and "Internet Box"
NicolasCGN schreef: 05 aug 2024, 19:53
They give you a public IP number (IPv4) that only changes if you restart the router, right?
You will receive:
- a dynamic public IPv4 adress, that can change if you restart the router. However, mostly it remains unchanged.
- a IPv6 /64 adress (SLAAC)
- a IPv6 /56 Prefix (PD)
NicolasCGN schreef: 05 aug 2024, 19:53
They don't give you a private IP number (IPv4), meaning that you are NOT behind a CG NAT, right?
Normally it is not CGNAT. In some cases
Proximus is using CGNAT, but you can allways opt-out.
Basically you have 3 options to run your local network:
- using the provider router (Proximus Internet Box): your devices will be behind a NAT
- using your own router behind the Internet Box: you can activate the "bridge" mode via "My Proximus" for your own router to obtain a public IPv4 adress (and also Ipv6).
- connecting your own router directly on the ONT (bypassing the Proximus router). In this case you need to set the VLAN-ID 20).
Later this year it will be allowed to use your own Fibermodem (in stead of the providers ONT)
.
Toegevoegd na 2 minuten 49 seconden:
qless schreef: 05 aug 2024, 21:05
Which provider will you use? (fiber and isp?)
Good question
In my answer above, I was assuming
Proximus (Fiber) and
Proximus (ISP)
